Kut Snake plastic fender flares Nissan Patrol Y61 1997-2004 55mm front pair

Kut Snake ABS plastic fender flares

• Solid and extremely flexible
• No painting required
• UV resistant (does not fade or crack in the sun)
• With stainless steel screws
• Includes rubber gasket and self-tapping screws
• ABS injection-molded plastic, black textured surface

Original KutSnake flares have an engraved logo, those without a logo are not KutSnake products. Counterfeit products may be of poor quality, fade, break and become brittle within a few months.

Note: Before ordering, please read the following information carefully. Installation requires drilling holes in the car. The fender flare may need to be cut or heated with a heat gun to fit perfectly. If you are not sure that you can install the flares, please consult a professional. We are not responsible for any defects or damage caused by improper installation of the product. The installation time is approx. 4-6 hours, depending on the model.

The temperature should be at least 20°C when installing the fender flares.

You can install KutSnake fender flares at home, but we recommend professional installation. The information in this guide is for informational purposes only and should not be interpreted as advice or recommendations for installation. Always seek professional advice before installation. Our company is not responsible for any damage resulting from installation by non-professionals.

Installation Guide

In order for the installation of KutSnake extensions to go smoothly, a little preparation is required. It is not difficult to install, but caution is required, as the bodywork needs to be drilled and this must be done accurately the first time. Here are some "tips" to ensure that the finished work looks perfect.

Required tools: 4 mm drill bit, if possible with a cordless electric drill, heat gun, Sikaflex or super strong glue, hot water

1. After unpacking the package, check that all pieces are undamaged, then prepare each piece for the appropriate side of the car. If your car has a fender flare, remove it and clean the area where you will install the KutSnake flare. Try it on by hand and check if there is any gap between the flare and the body curve.
2. Drill holes in the plastic flare with a 4mm drill bit. Do not use a larger drill bit, as the screws are sized for this.
3. Soften the rubber seal with hot water and then glue it with Sikaflex or similar to the upper half of the extension, which will fit the body.
4. Join the 2-piece extension, drill 3x10 mm holes through both pieces, then screw them together with 10 mm screws, so they will fit more precisely.
5. Place the extension against the body and drill 4 mm holes - using the holes drilled for the extension - in your car. Before screwing in the screws, put a little Sikaflex sealant in each hole to seal the screws, thus preventing rust. DO NOT OVERTIGHTEN THE SCREWS!
6. When all the extensions are in place, you can put the fender rubber on the extensions and add some flat head screws from below for extra fixation.
7. Finally, wipe the extensions with a soft cloth soaked in silicone for a nicer look....You're done!

Installation requires expertise!